2015PCchallenge, Cate van Alphen, chunky bead, handmade component, Indigo, marble, polymer clay, toggle
I was tempted to make more shank buttons this week for my indigo colour palette toggle, but then I realised time was running out for me to try some of the more interesting toggle mechanisms I’d planned at the beginning of the year.
This clasp is formed from two hooks. By aligning the angular cut holes of the two pieces at 90°, they slide together to form a chain link. It’s very satisfying to open and close :D.
The clasp is based on one from a chunky wooden bead necklace that I found in a charity shop, but I’ve made mine from polymer clay instead of wood. It took a few prototypes to get this far, and it is still a work in progress.
The first couple of clasps were a bit too flexible for my liking, but I didn’t really want to make everything a lot bigger and thicker. I put wire inside the third attempt as reinforcement, but you can just see it peeping through on the inside of the hole.
From the photos above it looks like I’ve cracked it, but turn one of the hooks over and there’s wire sticking out. I lost track of which side had the gap in the wire for cutting the hole through, and I chose the wrong place. Doh!
I’ve given the link a good pull apart and although the loops do flex open slightly (the one without the wire noticeably more so) I think a necklace made using the clasp would survive a tug from a toddler. So on the bright side cutting the wrong side helps to prove that the wire does provide some support, but also that I need to think of a way to keep track of where to cut ;).